1. Yüksek bağlantı güvenilirliği:
Menteşe pimleri, mekanik bileşenlerin göreceli konumunu ve hareketini sağlayan sabit bağlantılar sağlamak için hassas bir şekilde tasarlanmış ve üretilmiştir.
Ağır yük veya titreşim altında, menteşe pimleri bağlantıyı sabit tutar ve gevşeme veya düşme nedeniyle mekanik arızaları önler.
2. İyi esneklik:
Menteşe pimi, bağlı parçaların belirli bir aralıkta birbirine göre dönmesine izin verir ve bu esneklik, mekanik sistemin farklı çalışma koşullarına ve gereksinimlerine uyum sağlamasına olanak tanır.
Mekanik bileşenin konumunun veya açısının ayarlanması gerektiğinde, menteşe piminin esnekliği çalışma sürecini basitleştirir ve iş verimliliğini artırır.
1.Internal Thread Type, External Thread Type
Change N-part external thread to fine thread, Change to a four-sided wrench slot, Only applicable to stepped type
In this table, the N dimension in parentheses refers to the fine thread. When selecting, please change N to NC. Above
Add a guide section, Add the guide section at the position indicated in the left figure
Internal thread mounting type. When selecting Y and F, ensure that the t dimension in the figure is not less than the value shown in the previous table. If the bottom holes interfere with each other, they should be through holes.
2.Guided External Thread Mounting Type
One end with internal thread and one end with external thread type, Add guiding flat, Flange type
Nut fixing type, Tension pulley type, Split pin fixing type, Retaining ring fixing type
Hard chromium plating, coating thickness, Split pin, The tolerance refers to the L dimension, and others are general tolerances.
3.L Dimension Selection Type, L Dimension Specified Type, Accessory Split Pin Specification, Change split pin hole position (Note: L Dimension Selection Type is not applicable)
Change retaining ring groove position, Accessory retaining ring, Change internal thread diameter (Only applicable to the D specifications in the previous table)
Key fixing type, Lock screw fixing type, Double locking surface type (Only applicable to the lock screw fixing type)
4.Hinge Pin with Shoulder, Change Shoulder Thickness, Add Shoulder Stop Surface, Change Split Pin Position
With Hexagonal Hole Type, Ultra-thin Head Type, Zinc-plated U-shaped Nut, Stainless Steel U-shaped Nut, Change Thread Diameter
Change Thread Length, Hexagonal Hole Type Not Applicable, Shaft Diameter Tolerance Selection Type
T tolerance is the recommended tolerance when used with sleeveless bushings, Diameter d is a reference dimension, Only applicable to nut fixing type
Rolling Axle Pin, Retaining Ring Fixed Internal Thread Type
Step Screw for Fulcrum, Slotted Type, Head Cutting Type, Hexagonal Head Type, Add Relief Type
Free Specification Type, Fulcrum Pin, Short-head Hexagonal Hole Type
Step Bolt, Ultra-short Head Type, Short Head Type, Round Head Screw Type, Cross Slot Type
İngilizce
Rusça
İspanyolca
İtalyanca
Arapça
Kore dili
Almanca
Japonca
Vietnam dili
Türkçe
Giriş
Şartname Tablosu
İndirmek
